Unleash the power of 3D
Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #24554 Likes: 0
    Anonymous
    • Posts 1

    Newbie to Blender/BForArtists.

    Following “Blender 3D By Example,” I’m trying to get started with extrusion (the Viking helmet project).

    When I select two faces and perform an extrusion, I’m not getting the yellow “+” icon that apparently supports a repeat of the faces.

    #24555 Likes: 0
    BFA-Reiner
    Keymaster
    • Posts 598

    Hi generalpicture,

    How do you perform extrude? From the tool shelf? Or with the old legacy operators in the Mesh menu?

    The extrude widget is just available with the tool from the tool shelf.

    Kind regards

    Reiner

     

    Attachments:

    This is my signature. You can change your signature in the profile

    #24557 Likes: 0
    Draise
    Participant
    • Posts 1175

    If you are using the Blender keymap to extrude (E), you won’t be getting that widget. But if you use the Bforartists keymap which is S, then you will. The toolshelf operator has the widget. The act-once operator (or legacy operator) doesn’t have this widget.

    :dance:

    #24576 Likes: 0
    Anonymous
    • Posts 1

    How do you get to workspaces

    in bforatists

    #24577 Likes: 0
    BFA-Reiner
    Keymaster
    • Posts 598

    Hi,

    The same way than in Blender. By the tabs at the top, with the menu besides the tab, And by creating a new scene with corresponding workspace in the File menu.

    Kind regards

    Reiner

    Attachments:

    This is my signature. You can change your signature in the profile

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.